MULTIQUIP kubota Installation Instructions Manual

Kubota Water Heater Installation Instructions
(Multi-Models)
The following instructions are intended to assist the user in the installation of the Kubota Water Heater Kit. It is
recommended the following procedure be performed by a Multiquip Authorized Service Center (ASC) or by a
Multiquip Field Service Manager. Generator or engine failures caused by improper field installation are not covered
under a Multiquip Limited Warranty. Please read all assembly instructions before installing the kit.
REQUIRED TOOLS
„ Hammer
„ Ratchet W/ Extension
„ 1 inch socket
„ 6-8 inch hole/hammer punch
„ Channel Lock Pliers
„ Tape
„ Paint (High Temperature Resistant)
PARTS
Verify that all parts are accounted for. See Figure 1 and
Table 1.
Figure 1. Kubota Water Heater Installation Kit
KUBOTA WATER HEATER KIT INSTRUCTIONS (MULTI-MODELS) P/N 14254 — REV. #0 (12/14/15) — PAGE 1
T A
B O
E R
K U
A T
A C
H E N
/ D T I O
D A E R
N S
L A
A T
A L I O
C T
W
S T
R U
I N
S T
I N
Table 1. Kubota Water Heater Installation Kit
Item Part
Description
No. No.
1 13543 Kit, Kubota Water Heater, Multi-Models
2 14062 Heater, 400W, 115VAC, Kubota Block
3 14254 Instructions, Kubota Water Heater
4 777055 Carton, 6" x 6" x 6"
WORK SAFELY!
Only a qualified service technician with proper training
should perform this installation. Follow all shop safety rules
when performing this installation.
PREPARATION
1. Make sure generator is turned off and engine is cool.
2. Place the generator in an area free of dirt and debris.
Make sure it is on secure level ground. If trailer
mounted, place chock blocks underneath each wheel
to prevent the generator from rolling.
3. Open the right side cabinet panel to gain access to the
engine fuel supply and battery location.
QTY. Remarks
Includes
1
items 2-3
1
1
1