First Act grand prix Instruction Manual

Grand Prix MICROPHONE
INSTRUCTION MANUAL
Congratulations on your new Grand Prix microphone!
Please read this guide carefully before you begin playing.
BEFORE YOU PLA Y
Install Batteries
Always ask an adult to install batteries. This product uses 3 size AAA (1.5
V) batteries (not included).
The battery compartment is located on the back of the product.
Use a Phillips head screwdriver to open the compartment door.
Install batteries according to image inside of compartment.
Negative (–) and positive (+) ends of each battery must be installed
correctly, or an electrical hazard and/or damage to the product could
result.
Close compartment door and tighten screw to secure.
Note: If the batteries wear out, the product's sound may deteriorate. If
you are not going to play for a long time, remove the batteries from the
product. Do not mix old and new batteries. Do not mix alkaline, standard
(carbon-zinc), or rechargeable (nickel-cadmium) batteries.
MICROPHONE
1. BUtton 1
Press BUTTON 1 for a tire squeal
sound effect!
2. Button 2
Press BUTTON 2 to scroll through
3 movie lines.
3. on/off
Press this button to turn the mic
on and off.
4. Speaker
Please read this section carefull y.
Read and follow these instructions.
• Do not use this device near water.
• Clean only with a dry cloth.
• Do not use near any heat sources such as radiators, heaters, stoves, or
• Refer all servicing to qualified service personnel. Servicing is required
• To reduce the risk of fire and electric shock, do not expose this product
W arnings
Do not change the parts without professional instructions. Any change
may cause malfunctions.
Keep the wrapping bag out of the reach of children to avoid a choking
hazard.
Always move the product carefully to avoid damage to outer covering
and inner components.
The product should not come in contact with acid or alkali. It should
not be operated where there is corrosive or excessively moist air
around to avoid corrosion of the electrical contacts.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
• Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority
to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003.
1
Phone: 888.551.1115
2
Email: info@firstact.com
First Act Inc.
3
745 Boylston Street
Boston, MA 02116 USA
firstact.com
© Disney/Pixar
Visit the Disney website at www.disney.com/cars
No part of this publication may be reproduced in any form or by any means without the prior
written permission of First Act Inc.
Colors and specifications depicted on this guide may vary slightly from your product.
© 2012 First Act Inc.
All Rights Reserved.
CR955.M.EF.03
IMPORT ANT SAFETY inSTRUCTIONS
other heat producing machinery.
when the product has been damaged in any way, such as when liquid
has been spilled on it, it has been exposed to rain or moisture, it does
not operate normally, or it has been dropped.
to rain or moisture.
which the receiver is connected.
CUSTOMER ASSIST ANCE