Lorex LNR400 SERIES Instruction Manual page 31

9 Using the System
2. Configure the following settings as needed:
Note
The settings listed below are only shown if they are supported on the selected camera. Some cam-
era models do not support all settings.
• Mirror: Select Enable to flip the image horizontally.
• Flip: Select Flip 180° to flip the image vertically, or select No Flip for the default
orientation.
• 3D Denoise: Select Enable to turn on the camera's noise reduction feature. Noise
reduction will ensure a cleaner image, especially at night, and may reduce the
amount of disk space required to store video.
• BLC Mode: Select High or Low to enable back light compensation or Off to dis-
able. Back light compensation adjusts the lighting levels in the picture so you can
see objects in the foreground if there is a strong light source behind them.
• Scene Mode: The Scene Mode allows you to adjust white balance levels for the
camera. Select Schedule for the camera to automatically adjust the white balance.
Select Sunny or Night to use preset white balance levels. Select Customized to
manually set blue and red levels.
• DayLight: This setting sets the camera's day/night mode. Select Colorful for the
camera to use color mode at all times. Select Schedule for the camera to automati-
cally determine whether to use color or black and white mode. Select Black&White
for the camera to use black and white mode at all times.
Note
It is recommended to select Schedule mode, as using Colorful may impact the camera's perform-
ance at night.
• Saturation: Adjust the vibrancy of colors in the image.
• Hue: Adjust the color hue of the image.
• Brightness: Adjust the image brightness.
• Contrast: Adjust the image contrast.
3. Click OK to save changes.
Note
You must save changes to apply settings changes. It is recommended to adjust one setting at a time
so you can see the results of each change. Click Default to reset the camera to default image
settings.
#LX400021; r. 1.0/16017/16020; en-US
21