Cleaning The Monitor; Removing The Monitor Stand - HP EliteDisplay S230tm User Manual

Cleaning the monitor

For optimal performance you should regularly clean the touch screen and the touch screen reflectors
around the inside of the front bezel.
1. Turn off the monitor and unplug the power cord from the back of the unit.
2. Dust the monitor by wiping the screen and the cabinet with a soft, clean antistatic cloth.
3. For more difficult cleaning situations, use a 50/50 mix of water and Isopropyl alcohol.
CAUTION:
surface. Never spray the cleaner directly on the screen surface. It may run behind the bezel and
damage the electronics.
CAUTION:
thinner, or any volatile substance to clean the monitor screen or cabinet. These chemicals may
damage the monitor.

Removing the monitor stand

You can remove the monitor panel from the stand to install the panel on a wall, a swing arm, or other
mounting fixture.
CAUTION:
power and signal cables are both disconnected. Also disconnect the USB and audio cables
connected to the monitor.
1. Disconnect and remove the signal, power, USB, and audio cables from the monitor.
2. Lay the monitor face down on a flat surface covered by a clean, dry cloth.
3. Pull the easel stand up to the vertical position (1), remove the two screws that attach the stand
to the monitor (2), and then lift the easel stand off the monitor (3).
WARNING!
that it does not snap back and hit your hand while removing the screws.
14 Chapter 2 Setting up and using the monitor
Spray the cleaner onto a cloth and use the damp cloth to gently wipe the screen
Do not use cleaners that contain any petroleum based materials such as benzene,
Before beginning to disassemble the monitor, be sure the monitor is turned off and the
The easel stand is spring loaded so be sure to hold it firmly in a vertical position so