Asus Z170I PRO GAMING User Manual page 54

3-Core Ratio Limit [Auto]
Select [Auto] to apply the CPU default Turbo Ratio setting or manually assign a 3‑Core Limit
value that must be higher than or equal to the 4‑Core Ratio Limit.
If you assign a value for 3‑Core Ratio Limit, do not set the 1‑Core Ratio Limit and 2‑Core
Ratio Limit to [Auto].
4-Core Ratio Limit [Auto]
Select [Auto] to apply the CPU default Turbo Ratio setting or manually assign a 4‑Core Limit
value that must be higher than or equal to the 3‑Core Ratio Limit.
If you assign a value for 4‑Core Ratio Limit, do not set the 1‑Core Ratio Limit, 2‑Core Ratio
Limit, and 3‑Core Ratio to [Auto].
2.5.4 BCLK Frequency: DRAM Frequency Ratio [Auto]
Allows you to set the CPU bus speed to DRAM speed ratio mode.
[Auto]
[100:133]
[100:100]
2.5.5 DRAM Odd Ratio Mode [Enabled]
Allows you to enable or disable the DRAM Odd Ratio Mode, which provides better
granularity. Configuration options: [Disabled] [Enabled]
2.5.6 DRAM Frequency [Auto]
This item allows you to set the memory operating frequency. The configurable options vary
with the BCLK (base clock) frequency setting. Select the auto mode to apply the optimized
setting. Configuration options: [DDR4‑800MHz] [DDR4‑933MHz] [DDR4‑1066MHz] [DDR4‑
1200MHz] [DDR4‑1333MHz] [DDR4‑1400MHz] [DDR4‑1500MHz] [DDR4‑1600MHz] [DDR4‑
1700MHz]
Selecting a very high memory frequency may cause the system to become unstable! If this
happens, revert to the default setting.
2.5.7 TPU [Keep Current Settings]
TPU automatically overclocks frequency and voltage of CPU and DRAM to enhance the
system performance.
[Keep Current Settings]
[TPU I]
[TPU II]
2-20
DRAM speed is set to the optimized settings.
The BCLK frequency to DRAM speed ratio is set to 100:133.
The BCLK frequency to DRAM speed ratio is set to 100:100.
Keep the current settings without changing anything.
Applies air cooling overclocking conditions.
Applies water cooling overclocking conditions. Ensure that you
use a water cooling device before selecting the TPU II mode.
Chapter 2: Getting started