Makita LS1013 Instruction Manual page 27

Turn the hex bolt on the left side
I
of
the arm
two or
three revolutions
counterclockwise. Turn the hex bolt
on the right side of the arm two or
three revolutions counterclockwise to
tilt the blade to the left.
Carefully square the side
of
the blade
with the top surface of the turn base
using the triangular rule, try-square,
etc. by turning the hex bolt on the
right side of the arm clockwise. Turn
the hex bolt on the left side
of
the arm
clockwise as far as it will go. Then
tighten the lever securely.
Make sure that the two pointers on
the arm point to each 0" on the bevel
scale on the arm holder. If they do not
point to 0". loosen the screws which
secure the pointers and adjust them
so
that they will point to 0".
Bevel scale
S c r e w s - -
27