Table of Contents
Advertisement
■
Tune: Retunes each channel ([Manual Tuning]).
■
Rename: Renames the channel name.
Auto Tuning
Automatically retune the channels received in the area.
●
All the previous tuning settings are erased.
●
When the operation is completed, the channel at the
lowest position will be displayed.
●
Search begins in the order from the lower channels to
the higher channels.
●
If tuning has not been done completely
Tuning] (see below)
Manual Tuning
Normally use [Auto Tuning] or [Update Channel List] to
retune Digital TV channels.
If tuning has not been done completely or for adjusting
the direction of the aerial or dish, use this function.
●
All channels found will be added to the [Channel List].
■
Digital TV Manual Tuning
Digital TV Manual Tuning
Frequency
[CH21]
Signal Quality
Signal Strength
No.
Channel Name
1
Select frequency and offset
2
Search
■
Analogue TV Manual Tuning
Manual Tuning
1
Fine Tuning
1
Manual Tuning
Sound System
5.5MHz
Colour System
Auto
Store
■
Fine Tuning
Use to make small adjustments to the tuning of an
individual channel (affected by weather conditions, etc.).
■
Sound System
■
Colour System
Set Sound System and Colour System, and then
perform this function. Set Colour System [Auto] normally.
1
Select the channel position
●
If a VCR is connected only with the RF cable, select
channel position [0].
2
Select the channel
3
Search
4
Select [Store]
Update Channel List
You can add new channels, delete removed channels,
update channel name and position automatically to the
channel list.
●
The channel list is updated while keeping your
settings in [Favourites Edit], [Channel List], [Child
Lock], etc.
●
Depending on the signal condition, the update may
not work properly.
[Manual
MHz
474.00
Type
New
CH2
120
Updating the TV
Software
A new version of software may be released for download
to enhance the performance or operations of the TV.
[Setup]
[System Menu]
■
To update automatically
Set [Auto Update Search in Standby]
System Update
Auto Update Search in Standby
System Update Search Now
If System Update is performed, the software will
be updated (it may change TV functions).
If you do not want to do so, set [Auto Install] to
[No].
●
Every time you set, the TV automatically performs
a search in Standby and downloads an update, if
any software updates are available.
●
The automatic updating is performed in Standby
mode (TV turned off with the remote control).
■
To update immediately
1
Select [System Update Search Now]
2
Searches for an update (for several minutes) and
displays a corresponding message if any
3
Download
Note
●
Download may take a few hours.
●
During software download and update, DO NOT
switch off the TV.
●
The notification message might be a reminder. In this
case, the schedule information (the date that the new
version can be used) will appear. You can set the
reservation for update. The update will not start when
the TV is off.
[System Update]
Off
English
17
Hide quick links:
Advertisement
Table of Contents
