Installation - Sharp SJ-FP624V Operation Manual

INSTALLATION

WARNING
■ Do not install the refrigerator in a damp or wet
location as this may cause damage to the insulation
and a leakage. Condensation may also build on the
outer cabinet and cause rust.
1
Keep adequate ventilation space around the refrigerator.
• The figure shows the minimum required space for
installing the refrigerator. The amount of space
around the refrigerator affects the amount of power
consumption.
• Insufficient spacing will decrease cooling efficiency
and increase energy consumption. This may reduce
the life of the unit and void warranty.
90mm
or more
60mm
or more
Free standing type
2
Use the two front adjustable feet, to ensure that the
refrigerator is positioned firmly and flat on the floor.
3
When right and left doors are not properly aligned, adjust
using the adjustable feet.
When the left door is
raised.
Lower the foot
at right side.
(Until the adjustable foot on the
other side is slightly off-ground.)
4
60mm
or more
60mm
or more
1500 mm
Adjustable foot
When the right door is
raised.
Lower the foot
at left side.
4
Remove the 4 screws of the cabinet lower part, and
then set the foot cover (supplied inside the refrigerator
compartment) with removed 4 screws.
Screw
(4 screws)
5
Connect the power plug to a 230/240 volt. 10 amp.
power point.
NOTE
• Position your refrigerator so that the plug is accessible.
• Keep your refrigerator out of direct sunlight.
• Do not place next to heat generating appliance.
• Do not place directly on the ground. Provide suitable stand.
• If the mains power is switched on when the door is open, the
door alarm will sound. Close the door to stop the alarm.
Before using your refrigerator
Clean the inside parts with a cloth soaked in warm water.
If soapy water is used, wipe it off thoroughly with water.
Screw
Foot cover