Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Nectre Fireplaces 15 LE
Summary of Contents for Nectre Fireplaces 15 LE
-
Page 1: Operating Instructions
Nectre 15 LE Operating Instructions Efficient—Warm—Friendly Keep instructions in a safe place for future reference Do not throw away Pecan Engineering Pty Ltd proudly supports the activities of Landcare Australia through its membership of the AHHA... -
Page 2: Air Controls
USER INSTRUCTIONS SERIAL NUMBER 1. INTRODUCTION This number is required when ordering spare parts or making warranty claims. This can be found on the appliance Before use of this appliance please read these instructions specification label on the rear heat shield fully. -
Page 3: Recommended Fuels
Open the air spindle control on the door fully by 2. USING APPLIANCE FOR THE FIRST TIME turning it anti-clockwise to its full extent. Leave the door slightly open as the fire establishes and First few times the appliance is lit, it will give off some the glass warms to avoid the build-up of condensation. -
Page 4: Burning Tips
performance of the flue draught. Refer to installation guide Reload with more wood: for details on flue installation. Open air spindle before opening door. Factors affecting the flue draught include: Rake / break up any existing coals. Load the wood with the length orientated front to ... -
Page 5: 11. Troubleshooting Tips
10. CLEANING THE FLUE 11. TROUBLESHOOTING TIPS Check inside of flue prior to each season for any build-up of 1. Glass in door blackening creosote (wood tar). To do this:- This can have several possible causes: First remove the baffle (refer to “2. Replacement of Burning unseasoned wood —... -
Page 6: Maintenance And Servicing
MAINTENANCE and SERVICING 1. REPLACEMENT OF FIREBRICKS 3. REPLACEMENT OF BAFFLE PLATE The purpose of the firebricks in the appliance is to increase The 6mm thick steel baffle helps to retain the heat in the thermal mass and to guarantee the longevity of the steel firebox by lengthening the path of the flame so that they do firebox. -
Page 7: Fitting A New Door Seal
5. FITTING A NEW DOOR SEAL This task may be easier with the door removed from the appliance and laid horizontally on a work-bench. Remove any old seal from the door. Clean out the groove in the door that the seal was bedded in using a flat-end screw driver or equivalent. -
Page 8: Warranty
WARRANTY Pecan Engineering Pty. Ltd. warrants this stove to be able to operate under normal use and service and within 10 years from the date of the original purchase on the terms herein shall repair or replace without cost to the original customer any part thereof which shall be returned to our factory, transportation charges prepaid and which our inspection shows would prevent operation.