Related Manuals for Spirit Digital 328
Summary of Contents for Spirit Digital 328
- Page 1 V 2.0 Setup Guide Setup Guide Setup Guide Setup Guide Revised: 04-12-00...
- Page 2 Digital 328 v2, ADAT And BRC Setup Guide Contents: 1 1 1 1 Connecting The System 2 2 2 2 Digital 328 Setup 3 3 3 3 BRC and ADAT Setup 4 4 4 4 Notes On Single ADAT Operation...
- Page 3 ADAT Out ports of both the ADATs to the ADAT In ports of the 328 and vice versa. The ADAT connections allow digital transfer of either direct outputs for input channels 1-16 to the ADATs, or the Digital 328’s 8 Group outputs. 328 ADAT 1 Out ADAT 1 In...
- Page 4 Sync In Digital 328 To summarize, the connections required are as follows: BNC Wordclock cable: Digital 328 Wordclock out BRC Wordclock In MIDI Cables (required even if MIDI Timecode is not to be used): 328 MIDI Out BRC MIDI In...
- Page 5 Tape Ports Tape Ports To ensure that the Digital 328 Tape Ports are set to ADAT, enter the 328 Menu pages by pressing the <MENU> button on the right hand side of the LCD display. Using the encoder beneath the display, scroll up or down until the ‘Tape Port Select’...
- Page 6 <Tape Ch25->32 > Bank Source:ADAT <Tape Ch25->32 > Wordlength: MIDI MIDI MIDI MIDI To configure the 328 to send the MMC controls to the BRC and vice versa, the Alesis BRC must be selected in the Tape Machine Setup menu. Enter the Menu pages by pressing the <MENU> button, and scroll up or down with the encoder until the ‘Tape Mach Setup’...
- Page 7 <RECALL> button in the snapshot section of the Select Panel. < Setup#01 > ID :BRC 2 ADATS Before proceeding to the ADAT and BRC setup, RECALL THE SETUP as illustrated above and SWITCH OFF THE 328. Spirit Digital 328 v2...
- Page 8 BRC And ADAT Setup BRC And ADAT Setup BRC And ADAT Setup BRC And ADAT Setup Firstly, turn on the Slave ADAT. Allow a few seconds for the ADAT to boot correctly. Next turn on the Master ADAT. Allow a few more seconds for the ADAT to boot and recognize the Slave ADAT.
- Page 9 For a later model : Press <Digital Input> on BOTH ADATs. DO NOT DO THIS FROM THE BRC - THE DIGITAL I/O BUTTON SETS THE BRC INTO TRACK BOUNCING MODE. To complete the setup, turn on the 328 again. Spirit Digital 328 v2...
- Page 10 The 328 should now be set to generate wordclock at 44.1kHz (see NOTE above). The sampling rate will now remain lit on the ADAT display. Spirit by Soundcraft Harman International Industries Ltd., Cranborne House, Cranborne Road, Potters Bar, Herts EN6 3JN, England.