Table of Contents
Advertisement
Connecting the Scaler
The Projector
Channel Memories
1.
Connect all sources to the inputs of the scaler.
2.
Connect a HDmi cable from the video output on the scaler to input 2(DVi) in the projector.
3.
Connect power to the aC input using the provided power cable. The scaler will automatically
turn on. if a red leD is shown on the right side of the front panel, the Scaler is receiving aC
power but no signal is detected. if a Blue leD is shown, the Scaler is receiving aC power
and a good video signal is being detected. no leD indicates there is no aC power within
the scaler.
Component 1
Y
B-Y
R-Y
Sync
H
1
Video
S-Video
V
2
Y
B-Y
R-Y
Component 2 / RGBHV
all projectors come with 10 Channel memories that are pre-set for the scalers inputs, the
VariScope lens feature and VariScope 2.35 Anamorphic lens configurations; all based on the
installation specifications supplied by the dealer. Once the 10 Channel Memories are calibrated
at the installation, those channel memories can be copied to the remaining empty Channel
memory slots (11-99).
See the entire Channel memory chart at end of this Quick Setup Guide.
Channel 01
Channel 02
Channel 03
Channel 04
Channel 05
Channel 06
Channel 07
Channel 08
Channel 09
Channel 10
3
HDMI 1
HDMI 2
HDMI 3
HDMI 4
HDMI 5
Channel Memory Setup
HDmi 1 1.78
HDmi 1 1.85
HDmi 1 2.20
HDmi 1 2.35
HDmi 1 2.40
HDmi 1 2.35a
HDmi 1 2.40a
HDmi 1 2.60a
HDmi 1 2.67a
HDmi 1 2.70a
RS-232
GPIO
Output
Service
Video / Audio
Audio
IR Control
AC Input 110-240V, 50/60Hz
Wolf Cinema Quick Setup Guide
Advertisement
Table of Contents
