Samsung A837 Rugby User Manual page 84

Use the Up or Down Navigation key to highlight one of
3.
these options:
• MEdia Net
• AT&T MMS
• AT&T IMS
Press the Options soft key.
4.
Important!: The WAPs are pre-configured and cannot be altered on this
screen. The MMS connection option can be edited, renamed, or
deleted. Your phone is set up by default to connect to the
network. If you change the settings without checking with your
service provider, the web browser, MMS, and e-mail features
may not work properly.
To create a new connection, press the Options soft key,
5.
select New, and press the Select soft key or the
- Or -
To edit the existing MMS, highlight this entry, press the
Options soft key, select Edit, and press the Select soft key
or the key.
Select the parameter you want to edit:
6.
• Set Name: enter a profile name.
• Access Name: edit the access point name.
81
• Auth Type: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
• User ID: enter the User ID required to connect to the network.
• Password: enter the user password required to connect to the
network.
• Protocol: set the connection protocol used by the WAP browser:
WAP or HTTP.
• Home URL: enter the URL address of the homepage.
• Gateway address: (WAP only) enter the gateway address of the
proxy server.
• Proxy address: (HTTP only) set the proxy server address and port.
• Linger Time (Sec.): set a time period (in seconds) after which the
network is disconnected if there is no new data traffic.
• Advanced Settings: allows you to configure some of the IP-
specific information: Static IP, Static DNS, Server information, and
key.
Traffic Class.
– Static IP: specify if you want to manually enter an IP address. Remove
the check mark if you want the server to automatically assign the IP
address.
– Local phone IP: if you checked the Static IP option, enter the IP
address obtained from the network operator
– Static DNS: specify if you want to manually enter the Domain Name
Server (DNS) address. Remove the check mark if you want the server to
automatically assign the address.