Automatic Night Colours; Speed Warning Options; Speeding Tolerance; Alternative Speed Limit - Mio C710 User Manual

Navigation software for mio digiwalker c710

Hide thumbs Also See for C710:

Table of Contents

6.1.2 Automatic Night Colours

Using the automatic night mode, MioMap will change between the daylight and night

colour schemes a few minutes before sunrise and a few minutes after sunset based

on the time and location information provided by your GPS. Once you set a

permanent colour scheme in the Quick menu (Page 35), this automatic mode turns

off. If you need MioMap to switch between colours for you again, you need to re-

enable this feature.

When speed warning is turned on, the values of these controls determine when the

warning will be triggered.

You can set two different kinds of behaviour for the warning: one is applied up to a

certain speed limit and the other one is used above that.

MioMap will warn you when you exceed the speed limit by the amount specified

here. Select whether you want to specify the tolerance as a Fixed value (offset to the

speed limit) or as a Percentage.

The slider will change depending on which mode you have chosen.

Both positive and negative values can be given in either offset or percentage mode.

If the speed limit of the current road segment equals or is above this limit, the speed

warning will use the alternative tolerance instead of the previous one.

Move the slider to its rightmost position to turn off the alternative speed warning.

Then the settings of the upper slider will determine the warning for all roads.

If the speed limit of the current road reaches the value set at Alternative speed limit,

this setting will replace the basic one set at the top of this screen. The slider and the

selector work exactly as the basic ones described here: Page 64.

Table of Contents

Miomap v3.2