Mio 168 User Manual page 94

3. In the
General
network name is automatically entered and cannot be changed.
4. To change the network settings, select a network from the list.
•
From
Connects to
.
Internet
• To connect to an ad-hoc connection, select
(ad-hoc) connection
5. From
Networks to access
computer-to-computer
6. To connect only to networks you have already configured, clear
Automatically connect to non-preferred networks
NOTE: If you select to automatically connect to non-preferred networks, your Pocket PC
will detect any new networks and provide you the opportunity to configure them.
Configuring Authentication Settings
To determine if authentication information is needed, see your network
administrator.
1. To manually enter the information, select a network as described earlier and
tap
Authentication
2. To use data encryption, tap
3. To use Shared Key authentication, tap
You will need a network key (as provided by your network administrator).
4. To automatically use a network key, tap
automatically
5. For increased security, select
select the appropriate
Starting and Ending a Wireless Network Connection
After you install the wireless network card and set up the wireless network, use
the desired program when you are within the range of wireless network. For
example, switch to Pocket Internet Explorer and browse to a Web page. Your
Pocket PC will automatically connect.
84
tab, enter a network name. If the network was detected, the
, select what your network connects to,
.
, select
.
tab.
. Otherwise, enter the network key.
EAP type
,
All available Only access points
.
Data encryption (WEP enabled)
Network Authentication (shared mode)
The key is provided for me
Use IEEE 802.1x network access control
.
Work
This is a device-to-computer
or
.
or the
Only
.
. Then,