Electrical - Airstream 2015 Sport Owner's Manual

Interior
Faucets
Galley Faucet
moen, Chateau Single-Handled Kitchen faucet - model
67425
for parts and warranty, contact moen at 1-800-Buy
moen
Galley Faucet (22 ft. Model Only)
Smev/dometic, galley faucet/Sink Combo - model
Va7306aC
for parts and warranty, contact Smev at
(877) 898-7091
Lavatory Faucet (22 ft. Model Only)
Ramco, Single-handled lavatory faucet - model
ml201-SN
for parts and Ramco support contact (800) 321-4819
5-8
Faucet Cleaning and Care
all that is needed to clean your faucet is a soft, damp
cloth moen does not recommend the use of scour pads,
cleansers, or chemicals The abrasive nature of these
substances could damage the faucet's finish. A non-
abrasive car wax will help to protect the finish.

Electrical

Battery/12-Volt System Information
The major portion of electrical power in your airstream is
12-volt The 12-volt current powers all gas appliances for
controls and/or ignition as well as lighting an exception
would be the range which has its own ignition source
all 12-volt current comes through the battery system
in the front of your trailer The batteries are accessible
in the battery box on the a-frame of your trailer Power
from the batteries goes to a set of four Type 2 thermal
breakers located under the front bed and riveted to the
inside skin front plate The breakers are tied together
by a brass bus bar One breaker (30-amp) protects the
12-volt tow vehicle charge line coming from the 7-way
cord another breaker (20-amp) feeds the trailer brakes
breakaway switch located near the hitch coupler a
50-amp breaker feeds the battery disconnect relay
The current leaves the relay and travels to the 12-volt
distribution panel, located in the converter, and then to
the rest of the trailer Open the brown decorative door on
the front of the converter under the dinette to access the
panel and its fuses a 12-volt layout diagram is shown in
Section 8 - maintenance
If you replace a blown fuse and it immediately blows
again, do not replace the fuse again until a qualified
service technician can correct the problem
If the replacement fuse holds for a week or more and
the gap in the fusible metal is barely melted apart, this
usually indicates an overload condition Reducing the
number of lights or appliances used on that particular
circuit at the same time could prevent any further fuse
failure
Refer to Section 8 - maintenance for important battery
maintenance information
Sport