Cd Mechanism Section - JVC KD-LX300 Service Manual

KD-LX300/KD-LX100
<CD mechanism section>
Removing the CD mechanism control
board (See Fig.1 and 2)
1. Remove the screw A and the pickup cover attached
to the front bracket with the double-sided tapes.
2. Unsolder the three parts a, b and c on the CD
mechanism control board.
3. Remove the stator fixing the CD mechanism control
board and the damper bracket (To remove the stator
smoothly, pick up the center part).
4. Remove the screw B attaching the CD mechanism
control board.
5. Remove the CD mechanism control board in the
direction of the arrow while releasing it from the two
damper bracket slots d and the front bracket slot e.
6. Disconnect the flexible wire from connector on the
pickup unit.
ATTENTION: Turn the FD gear in the direction of the
arrow to move the entire pickup unit to
the appropriate position where the
flexible wire of the CD mechanism unit
can be disconnected easily (Refer to
Fig.2).
Removing the loading motor
Prior to performing the following procedure, remove
the CD mechanism control board and the pickup
cover.
1. Remove the two springs f attaching the CD mechanism
assembly and the front bracket.
2. Remove the two screws C and the front bracket
while pulling the flame outward.
3. Remove the belt and the screw D from the loading
motor.
1-10
Pickup cover
B
Double-sided tape
(See Fig.3 to 5)
Spring f
Pull outward
Damper bracket
A
E
b
Front bracket
Fig.1
Pickup unit
FD gear
Fig.2
CD mechanism control board
C
Loading motor
Front bracket
Fig.3
Flame
Fig.4
E
a
E
d
CD mechanism
control board
e
c
Flexible wire
Shift the lock
Spring f
C
Pull outward
Front bracket