MB QUART N1-RFBT Quick Start Installation Manual

Congratulations on your choice of a MBQuart Bluetooth
controller. This "Quick Start" Installation guide is meant to
help you complete a basic installation. For more detailed
information, visit our website at MBQuart.com
CAUTION
Always consider consulting a professional audio installer
before installing any audio components. Be careful and take
your time. Do not let wires make contact with metal edges or
hot engine components.
Flush Mounting
This method will allow the controller to sit fl ush to the mounting
surface. This requires a perfectly fl at surface and ideally should have
access to the rear of the mounting panel.
Before drilling the mounting hole, make sure there are no
obstructions behind the mounting area.
35mm (1-3/8")
minimum clearance
55mm
2.18" (2-3/16")
Surface Mounting
The controller can be mounted on any fl at surface using the surface
mount cradle. This will allow the controller to be removed for use in
hand as well as kept in the cradle when not in use.
Before drilling any holes make sure there are no obstructions behind
the mounting surface. Also make sure there is enough space around
the cradle to remove and replace the controller easily.

Battery Replacement

The controller battery can be changed by sliding the access door
downward.
CR2032
Wiring
The wiring and connections should be secure and away from any
moving parts or extremely hot surfaces.
The RCA pre amp output can be connected directly to an amplifi er.
The RCA aux input can be used to connect a secondary source.
The remote input wire should be connected to a switched +12V
source.
The remote output wire provides a +12V output to turn on an
amplifi er.
PRE AMP OUT
AUX IN
REMOTE OUT
GROUND (black)
+12V (red)
REMOTE IN (blue)
USB Charger
Status Indicator