Chevrolet 1998 S10 Owner's Manual page 287

1. Remove the headlamp assembly as-shown under
"Two-Pie-ce Composite Headlamp System" ,earlier in
this section,
2 . Lacate the locking tabs
-on the assembly.
Squeeze the tabs
together and push.that
end of the-assembly out
while holding the tabs.
-The assembly will
.swing .out.
3. Unplug the electrical conne-czw.
6.
7.
6-38
4.
5.
Turn the harness bulb socket to the left
to
remove
it.
Push the new
b.ulb
into the socket until it. snaps
into place.
Put the new bulb into the headlamp. lens- assembly
and turn
it
to the right until it is. tight.
To replace the .assembly, snap the outboard end of
the lamp assembly back into the vehicle. Then swing
the assembly in
,and
snap it into place.