Paper Setup - Sharp AR-C150 Service Manual

D. Paper setup
1) Push down the lock lever until it stops to release the tray lock.
(AR-C100 only)
Lock lever
2) Lift the grip upward, and pull out the paper tray slowly until it
stops.
3) Set the paper below the indication line.
At that time, set the paper size detection lever according to the set
paper size.
•
(Note) Curled paper, folded paper or copied paper may cause
paper jams.
•
When pulling out the tray, do not put a heavy thing on it or
do not press it.
4) Push the tray into the machine slowly and securely.
5) Push up the lock lever until it stops to lock the tray. (AR-C100
only)
Lock lever
(AR-C100 only)
Indication line
Paper size detection lever
4 – 12
•
(Note) When a tray is pulled out during copying, a paper jam may
occur. When a paper jam occurs in the tray, if the tray is
pulled out, the jammed paper may be torn.
•
Be sure to lock the tray after supplying paper in order to
prevent the copy user from pulling out the tray carelessly.
(AR-C100 only).
7. Parts setup
(1) Paper exit tray setup
(2) Front cabinet stopper setup
(3) Horizontal level check and adjustment
If the copier is tilted back and forth, the following troubles may be
caused.
•
Oil leak from the fusing section
•
Image distortion and color image resist
To avoid the above troubles, check the horizontal level of the copier
back and forth and adjust if necessary. A small tilt in left and right
direction is allowed due to the margins.
a. Necessary tools
•
Horizontal level check sheet (UKOG-0286FCZZ)
•
Screw (LX-BZ0870FCZZ)
4 lock release/C transfer section/Use screws other than the screws
removed in Procedure 7).
•
Horizontal level check string (with washer) (UKOG-0285FCZZ)
•
Spacer disk (UKOG-0287FCZZ)
•
Spacer (UKOG-0288FCZZ)
b. Check and adjustment
1) Paste and attach the horizontal level check sheet to the edge of
the cabinet.
AR-C150