Toshiba RAV-SM562UT-E Installation Manual page 11

REQUIREMENT
Before installation of the indoor unit, be sure to
remove the cushion for transportation between the
fan and the bell mouth. Running the unit without
removing the cushion may damage the fan motor.
Be sure to remove the cushion for transportation
between the fan and the bell mouth.
Installation of ceiling panel
(Sold separately)
Install the ceiling panel according to Installation
Manual attached with it after piping/wiring work has
completed.
Check that installation of indoor unit and ceiling
opening part is correct, and then install it.
REQUIREMENT
Joint the connecting sections of ceiling panel,
ceiling surface, ceiling panel and indoor unit
closely.
Any gap between them will cause air leakage and
this generate condensation or water leakage.
Installation of remote controller
(Sold separately)
For installation of the wired remote controller, follow
the Installation Manual attached with the remote
controller.
• Pull out the remote controller cord together with the
refrigerant pipe or drain pipe.
Be sure to pass the remote controller cord through
upper side of the refrigerant pipe and drain pipe.
• Do not leave the remote controller at a place
exposed to the direct sunlight and near a stove.
• Operate the remote controller, confirm that the
indoor unit receives a signal surely, and then install
it. (Wireless type)
• Keep 1m or more from the devices such as
television, stereo, etc.
(Disturbance of image or noise may generate.)
(Wireless type)
In case of wireless type
The sensor of indoor unit with wireless remote
controller can receive a signal by distance within
approx. 7m. Based upon it, determine a place where
the remote controller is operated and the installation
place.
• To prevent a malfunction, select a place where is not
influenced by a fluorescent light or direct sunlight.
• Two or more (Up to 6 units) indoor units with
wireless type remote controller can be installed in
the same room.
8