Table of Contents
Advertisement
Install the cassette type indoor unit
Note
1. Improper screwing of the screws may cause the troubles shown in fig.5.
2. If gap still exist between ceiling and decoration panel after tightening the screws, readjust the height of the indoor unit.
(As shown in fig.6)
Gaps are not allowed
※ After fixing, be sure no gap left between the ceiling and the panel.
3. Wiring of the decoration panel (Fig.7)
☆ Connect the joints for swing flap motor lead wire (at 2 places) installed on the panel.
At body
Air leak
Air leak from ceiling
Fig.5
Fig.6
At pane
Fig.7
Water condensatation, water drop
If the raising lever and drain hose are
not affect, can adjust the height of
indoor unit by the hole on the corner
of panel.
At body
13
At pane
Advertisement
Table of Contents
