Table of Contents
Advertisement
2.6 S elect Terminal keys f or Function, Arrow, and Ctrl keys. Ensure t hat you s elect T erminal k eys ( not
Windows keys).
NOTE: When you use HyperTerminal with the Microsoft® Windows® 2000 operating
system, ens ure t hat you have Windows 20 00 Service P ack 2 or l ater i nstalled. Windows
2000 S ervice P ack 2 al lows you to us e ar row k eys i n H yperTerminal's V T100 emulation.
See www.microsoft.com for information on Windows 2000 service packs.
3. After you have correctly set up the terminal, plug the power cable into the power receptacle on the back of the
Switch. The boot sequence appears in the terminal.
4. After the boot sequence completes, the console login screen displays.
5. If you have not logged into the command line interface (CLI) program, press the Enter key at the User name
and password prompts. There is no default user name and password for the Switch. The administrator must
first create user names and passwords. If you have previously set up user accounts, log in and continue to
configure the Switch.
6. Enter t he c ommands t o c omplete your des ired t asks. Man y c ommands r equire adm inistrator-level ac cess
privileges. Read the next section for more information on setting up user accounts. See the DGS-3700 Series
CLI Manual on the documentation CD for a list of all commands and additional information on using the CLI.
7. When you h ave c ompleted your t asks, ex it t he s ession with t he l ogout c ommand or c lose t he em ulator
program.
8. Make sure the terminal or PC you are using to make this connection is configured to match these settings.
If you are having problems making this connection on a PC, make sure the emulation is set to VT-100. You will be
able to set the emulation by clicking on the File menu in you H yperTerminal window, clicking on Properties in t he
drop-down menu, and then clicking the Settings tab. This is where you will find the Emulation options. If you still do
not see anything, try rebooting the Switch by disconnecting its power supply.
Once connected to the console, the screen below will appear on your console screen. This is where the user will enter
commands to perform all the available management functions. The Switch will prompt the user to enter a user name
and a password. Upon the initial connection, there is no user name or password and therefore just press "enter" twice
to access the command line interface.
Copyright(C) 2009 D-Link Corporation. All rights reserved.
UserName:
DGS-3700 Series Layer 2 Gigabit Ethernet Switch Hardware Installation Guide
DGS-3700-12 Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.00.B031
Figure 4- 1. Initial screen after first connection
17
Advertisement
Table of Contents
