Table of Contents
Advertisement
3. GeNeRAL DeSCRIpTION
The A-5006/5012 is a compact desktop integrated Mixer Amplifier with a 4-input/1-output configuration. The
4 inputs include an assortment of line and microphone inputs. The unit is equipped with a terminal that allows
remote control of overall sound volume. Signal processing, including equalization and compression, can be
performed using the supplied A-5000 PC Software.*
The unit can also be easily mounted in an EIA-standard equipment rack with the additional purchase of optional
rack mounting hardware. Horizontal connectivity permits two mixer amplifiers to be simultaneously mounted in
a one-unit size rack space.
* Recorded on the supplied CD.
4. feATUReS
• The input sensitivity of Inputs 1 and 2, and impedance of the speaker outputs are set by way of a DIP switch
located on the unit's rear panel.
• The input sensitivity of Inputs 1 and 2 can be independently set to either MIC or LINE signal level. Inputs 3
and 4 are fixed at LINE level.
• Speaker outputs can be set for either low or high impedance connections.
• A manual muting function and a remote master volume control function allow remote adjustment of the sound
volume.
• The unit is equipped with the LAN port, making it possible to perform the unit's settings using the A-5000
PC Software. Functions that can be set include an input equalizer, output equalizer, compressor and remote
master volume.
5. HANDLING pReCAUTIONS
• The supplied power cord is designed to be used exclusively with the unit. Do not connect it to any other
equipment.
• Install the unit in locations where the temperature is between 0 and 40 °C (32 and 104°F) and the moisture is
between 35 and 80% (no dew condensation must be formed).
• The unit is a precision audio component. To prevent failure, avoid locations where the unit may be exposed
to strong shocks or vibrations.
• To clean, be sure to first switch off the unit's power, then wipe with a dry cloth. Never use benzene, thinner,
alcohol, or chemically-treated cleaning cloth because such volatile liquids could deform or discolor the unit.
6. INSTALLATION pReCAUTIONS
• Be sure to install and connect the unit before the connection to the AC mains outlet. Remove the unit's power
supply cord from the AC mains outlet when uninstalling or disconnecting the unit.
• The socket-outlet shall be installed near the unit and the plug shall be easily accessible.
• Ensure that the unit is located at least 10 cm (3.94") away from ceiling and wall surfaces, as shown in the
figure below, to allow adequate cooling and thus prevent extreme increases in temperature inside the unit.
Also, do not place any other devices within that range.
8
Over 10 cm
(3.94")
Over 10 cm
Over 10 cm
(3.94")
(3.94")
Advertisement
Table of Contents
