Remote Connection; Selecting The Default Settings - Sony TRINITRON BVM-A20F1U Operation Manual

Remote connection

1
Set the different IP address to each monitor and
controller.
2
Set the different monitor ID No. to each monitor and if
necessary, group ID No..
3
Set the NETWORK switch (on the rear) of the monitor
and the controller to LAN.
4
Select the connection mode by pressing the SINGLE,
GROUP or ALL button.
The lamp corresponding with the pressed button
flashes and lights after recognizing the monitor.
5
Select the monitor ID No. for the single connection
mode or group ID No. for the group connection mode
by pressing the UP/DOWN or numeric button.
Up to 99 is entered as the monitor ID or group ID No..
6
Press the ENTER 3 or Ent q; button to confirm the
setting.
The monitor ID No., group ID No. or ALL is displayed
in the display window.
After setting steps 1 to 3, follow steps 4 to 6 for the remote
connection.
Notes
• When no assigned monitor ID No. or group ID No. is
selected, setting is not changed and the previous
connection status is maintained.
• When there is same monitor ID No., the ID No. with the
lower IP address is selected.
• When the different monitor ID No. is set but the same IP
address as that of another monitor is set, the monitor
cannot be connected to the network.
• To remotely control monitors connected in the network,
the MONITOR ID, GROUP ID or IP address of
monitors should be correctly set in the NETWORK
menu and NETWORK SETTINGS menu of the
SYSTEM CONFIGURATION menu. Also, the IP
address of the monitor should be correctly set in the
NETWORK SETTINGS menu of the CONTROLLER
menu.
For information about the NETWORK menu and
NETWORK SETTINGS menu, see "
Configuration – SYSTEM CONFIGURATION Menu"
on page 42.
For information about the NETWORK SETTINGS menu,
[H]
see " Setting the Controller – CONTROLLER Menu"
on page 54.
24
Selecting the Default Settings / Selecting the Default Settings
Selecting the Default
Settings
BVM-A20F1M only
When you turn on the unit for the first time after
purchasing it, select the area where you intend to use this
unit from among the options. When the area is set, the
color temperature of CH1 to CH30 is set to the default
value of each area.
JAPAN
OTHER AREA
1
2
[D]
System
Color temperature
D93
D65
Turn on the power.
The SELECT SETTING screen appears.
S E L E C T S E T T I N G
J A P A N
C O L O R T E M P : D 9 3
O T H E R A R E A
C O L O R T E M P : D 6 5
Select the area where you intend to use the unit by
using the menu operation buttons (see page 25).