Advertisement
Advertisement
Table of Contents
Summary of Contents for Nakamichi DELTA 20
- Page 1 DELTA 20 User manual...
- Page 3 Delta 20 DAB/FM Radio with Bluetooth Instruction Manual CAUTION: Risk of electrical shock. Do not open the unit. 1. Please read, keep and follow these instructions. 2. Install in accordance with the manufacturer’s instructions. 3. Do not install near any heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.
-
Page 4: Front View
FRONT VIEW DISPLAY SCREEN: LCD featuring special icons. Volume knob with Standby key & Scrolling Up/Down function: • During Standby, short press to switch ON the radio. • During operation, long press to switch the radio to STANDBY. • During Alarm, short press to SNOOZE. •... -
Page 5: Installing/Replacing The Battery
Remove the protection slip from the remote control battery compartment as shown below. Your Nakamichi Delta 20 comes supplied with one CR2025 battery. Connect the power adaptor’s DC plug to the power jack on the back of your product. Then connect the power plug to your AC outlet. -
Page 6: Remote Control
REMOTE CONTROL STANDBY: Press this button to either turn on or put on standby. MODE: Press to switch between DAB, FM, BT and AUX mode. INFO: In DAB, FM mode, while receiving a broadcast signal, press this button to display information. SCAN: Press to do full scan of station in DAB mode / Press to scan for next station in FM mode. -
Page 7: Listening To Dab Radio
LISTENING TO DAB RADIO A scanning operation will be done when the unit is switched ON for the first time. The DAB icon will light up, and the scanning procedure is started: The scanning procedure could take up to a minute to complete. - Page 8 For first time use, the unit will go to Pairing mode automatically and the Blue LED will flash slowly. Turn ON your Bluetooth device (e.g. Smart Phone) settings and scan for devices, “Delta 20” will be shown on your device’s Bluetooth list.
- Page 9 LISTENING TO AUXILIARY AUDIO Connect a media player (i.e. Smart Phone) to the aux-in jack on the back of your unit (AUX cable not supplied). Select AUX IN as the audio source using the key on the remote control. “AUX IN” will appear in the display. Rotate the VOLUME knob on the front panel or press the +/- key on the remote control to adjust your volume level.
- Page 10 ii) FM mode ONLY SCAN SETTING: Select STRONG or ALL for scanning reception STRONG: Scanned for stations received with strong signals only. ALL: Scanned for all stations received with strong and weak signals. AUDIO SETTINGS: Set FM MONO/STEREO mode iii) Available in All Mode DATE / TIME SETUP: Set the Date and Time manually or synchronised to the DAB / FM broadcast signal SET TIME: Press on the remote or rotate the VOLUME knob on the front panel to adjust the time and...
- Page 11 TIMEOUT setting (18 SEC - ON) LEVEL setting (LOW / HIGH / MEDIUM) Press on the remote or rotate the VOLUME knob on the front panel to adjust the timeout duration or the level of brightness, followed by pressing on the remote or pressing on the VOLUME knob to confirm and save.
-
Page 12: Using The Alarm
USING THE ALARM i) Set the Alarm Switch ON the radio, press key on the remote control to select ALARM 1 or ALARM 2, a blinking icon will be shown on display. Press start, press on remote or rotate the VOLUME knob on the front panel to adjust the setting, then press or press on the VOLUME knob to confirm and go to the next setup item, or press... -
Page 13: Troubleshooting And Support
If your DAB+ Clock Radio does not work as expected please first read this manual. No operation: Check the power adaptor and main power have been turned on. If still not successful please contact Nakamichi Service Support. Please refer to page 12 for details. WHAT’S INCLUDED •... - Page 14 Email: warranty@nakamichi-ap.co.nz Website: www.nakamichi.com.au Address: 84 Kerrs Road, Manukau Auckland 2104 New Zealand Hours of Operation Monday - Friday 9am to 5:00pm excluding Public Holidays Or visit the Nakamichi website anytime 24/7 and use the e-warranty service to make a claim.