Fault Messages In The Display - Miele NOVOTRONIC W 1612 Operating Instructions Manual

Fault messages in the display

Problem
The display lights up
and
Drain fault
flashes.
The display lights up
and
Water inlet fault
flashes.
The display lights up
and
Waterproof fault
flashes.
The display lights up
and
Technical fault
flashes.
The display flashes
Anti-crease
Chk detergent
To switch off the fault message: Use the I-On/0-Off button to switch the washer
off.
Possible cause
– The water outlet is
restricted or
blocked.
– The drain hose is
sitting too high.
The water inlet is
blocked or restricted.
The water protection
system was triggered.
There is a fault.
Excessive foam has
built up during
washing.
Troubleshooting
Remedy
– Clean the drain filter and
pump.
– The max. drain pump
height (delivery head) is
1m.
Check whether:
– the stopcock is open
enough.
– the inlet hose is pinched or
bent.
– the water pressure is too
low.
Call the service department.
Re-start the program.
If the fault message appears
again, call Customer Service.
Use less detergent next time,
and check the recommended
doses on the package.
35