Brushing Modes; Clean Mode; Deactivating Or Activating The Easy-Start Feature - Philips Sonicare 700 series Instructions Manual

ENGLISH
8
4235.020.2528.2.indd 8 4235.020.2528.2.indd 8
2 After the 2 minutes of Clean mode, the White mode begins with
a change in brushing sound and motion. That is your signal to start
brushing the upper front teeth for 15 seconds
3 At the next beep and pause, move to the bottom front teeth for the
fi nal 15 seconds of brushing.

Brushing modes

Sonicare automatically starts in the default Clean mode. To select a
different brushing mode:
1 Press the on/off button to toggle between modes.
The green LED indicates the selected mode.
,
Note: You can only switch between modes when the toothbrush is turned on.

Clean mode

Standard mode for superior teeth cleaning.
Sensitive mode (select models)
Gentle, yet thorough cleaning for sensitive gums and teeth.
Clean and White mode
2 minutes of Clean mode, with an additional 30 seconds of White mode to
focus on your visible front teeth.
Note: When Sonicare is used in clinical studies, the default 2-minute Clean
mode must be selected. However, in whitening/stain reduction studies, the
Clean and White mode must be selected. The handle should be fully charged
and the Easy-start feature deactivated.
Features
Easy-start
- This Sonicare model comes with the Easy-start feature activated.
- The Easy-start feature gently increases power over the fi rst
14 brushings to ease into the Sonicare experience.
Note: Each of the fi rst 14 brushings must be at least 1 minute in length
to move through the Easy-start ramp-up cycle properly.
Note: When the Clean and White mode is selected, the Easy-start feature is
inactive.

Deactivating or activating the Easy-start feature

1 Attach your brush head to the handle.
2 Place the handle in the plugged-in charger.
- To deactivate Easy-start:
Press and hold the power on/off button for 2 seconds. You hear 1 beep to
indicate that the Easy-start feature has been deactivated.
- To activate Easy-start:
Press and hold the power on/off button for 5 seconds. You hear 2 beeps to
10-07-2008 10:56:34 10-07-2008 10:56:34