Advertisement
Before you start...
Proper installation
is your responsibility.
Make sure you have everything
necessary
for correct
installation.
It is
the responsibility
of the installer to
comply
with the clearances
specified.
Check the location
where the range
hood will be installed.
The location
should be away from strong draft areas,
such as windows,
doors, and strong
heating
vents.
knockouts
30" model:
29-7/W
wiring I
knockouts
RH2330 Series
Panel A
Electrical Shock Hazard
It is the customer's responsibility:
. To contact a qualified
electrical installer.
. To assure that the electrical
installation is adequate and in
conformance
with National
Electrical Code, ANSI/NFPA
704atest edition*, and all local
codes and ordinances.
Failure to do so could result in fire,
electrical
shock or other personal
injury.
Care must be taken when
drilling holes into wall. Electrical
wires may be concealed
behind
the wall covering.
Failure to do so could result in
electrical
shock or other personal
injury.
Personal Injury Hazard
Reaching over a heated
cooking
surface should be
avoided.
To reduce the hazard
of being burned, the range hood
should extend a minimum of 5
inches out from the bottom of
the cabinet.
Reaching over a heated
cooking
surface could result in a serious
burn.
Important:
Observe all governing
codes and ordinances.
Tools and
materials needed
for installation:
l
saber or keyhole
saw
l
duct tape
l
metal snips
l
Phllllps rcrewdrlver
l
ruler
l
encll
P
l
evel
l
caulklng
gun
l
drill
l
l-1/4'drlll
bit
l
pliers
. compass
or
7' circle template
Mobile home installation
The installation
of this range hood must
conform
to the Manufactured
Home
Construction
and Safety Standards,
Title
24 CFR, Part 3280 (formerly
the Federal
Standard
for Moblle
Home Construction
and Safety, Title 24, HUD, Part 280) or
when such standard
Is not applicable,
the Standard
for Manufactured
Home
lnstallatlon
1982 (Manufactured
Home
Sites, Communities
and Setups), ANSI
A225, l-l 987, or latest edition,
or with
local codes.
Four-wire power
supply must be used
and the appliance
wiring must be
revlsed. See Electrlcal
requirements.
Copies of the standards
listed may be
obtained
from:
l
National Fire Protection Association
Batterymarch Park
Quincy,
Massachusetts
02269
Advertisement
