Networking Setting Page; Figure 10: Network Setting Page - Grandstream Networks GXV3662_HD/FHD User Manual

Networking Setting Page

This page allows user to configure network related parameters:
•
IP Address Configuration:
o Dynamically Associated via DHCP:
camera.
o Statically Configured as:
•
DNS Configuration:
•
HTTP:
NOTE:
 If camera behind SOHO router with port forwarding configuration for remote access, static IP or
static DHCP has to be used to avoid IP address change after router reboot.
 TCP port above 5000 suggested if port forwarding HTTP remote access, due to some ISP would
block port 80 inbound traffic. For example, change the default HTTP port from 80 to 8088, to
make sure the port forwarding not likely be blocked.

In addition to HTTP port, RTSP port also required to be configured for port forwarding, in order
for remote party viewing the H.264 video.
 If change the default port from TCP 80 to port "A", then RTSP port should be "2000+A". Both
TCP port "A" and "2000+A" should be configured for port forwarding in the router. For
example, the HTTP port changed to 8088, the RTSP port should be 10088, both 8088 and 10088
should be configured for port forwarding in order for remote camera video access.
Grandstream Networks, Inc.

Figure 10: Network Setting Page

Camera IP address configuration
Default setting, DHCP server assign IP to
Static IP address configuration
DNS server IP must be configured correctly if using static IP.
Web access TCP port, default 80.
GXV3662_HD/FHD User Manual
Firmware Version 1.0.1.93
Page 41 of 69
Last Updated: 11/2015