Table of Contents
Advertisement
Certifications
Hereby, SmartThings Inc. declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC. The
original Declaration of Conformity may be found at
smartthings.com/eu/compliance.
Certified under FCC Part 15
Certified in Canada by IC to RSS-210
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
Arrival Sensor FCC ID: R3Y-STSS-ST001, M/N: STSS-PRES-001,
IC ID:10734A-STSSST001.
FCC Statement
Operation of this device is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation
of the device.
Tested to Comply With FCC Standards
FOR HOME OR OFFICE USE
Canada Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est aurorisee aux deux
conditions suivantes: (1) l'appareil ne doit pas pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter toute brouillage radioelectrique subi,
meme si le brouillage est susceptible d'en compromettre le fonctionnement.
Information to the User
Changes or modifications not expressly approved by SmartThings, Inc. could
void your authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Advertisement
Table of Contents
