Battery Installation; Installing The Belt Clip - Midland GXT300 Series Owner's Manual

Model GXT300/325/310/400/450 Series

BATTERY INSTALLATION

Your GXT300/325/310/400/450 Series radio operates with either 4 AA
alkaline batteries or an optional NiMH battery pack. The belt clip
should be removed (see below) to ease installation or removal of the
batteries.
To install the batteries:
1. With the back of the radio facing you, remove the belt clip (see
diagram below) for easy access, then remove the Battery Cover
by pressing down on the top center and sliding it down from the
radio.
2. Insert 4 AA batteries observing the polarity as shown. Installing
the batteries incorrectly will prevent the unit from operating or
may damage the unit.
3. Return the Battery Cover by sliding it up on the radio. Replace the
belt clip, making sure it locks into place.
One Battery inserted
in this slot
BATTERY
COMPARTMENT
BATTERY
COMPARTMENT
COVER
Press here and
push down to open

INSTALLING THE BELT CLIP

To install the BELT CLIP, slide the clip down into the slot on the back
of the radio until the BELT CLIP LATCH clicks. To remove the BELT
CLIP, press the LOCK TAB down , then gently pull the belt clip up
toward the top of the radio.
Page 6
BELT CLIP
LOCK TAB
BELT CLIP
LATCH
www.midlandradio.com
®