Related Manuals for Meyer Sound HM-1
Summary of Contents for Meyer Sound HM-1
-
Page 1: Operating Instructions
Operating Instructions HM-1 Self-Powered Reference Monitor Patents Pending Copyright © 1997 Meyer Sound Laboratories, Inc. All rights reserved Part # 05.039.003.01 Rev A2... -
Page 2: Table Of Contents
Office of Quality Manager on each of 6 sides Berkeley, California USA Vibration: 10 – 55 Hz (0.010 m April 1, 1997 peak-to-peak excursion) Made by Meyer Sound, Berkeley, CA, USA U U L L LISTED European Office: Meyer Sound Germany 3K59 ®... -
Page 3: Introduction
Using the Meyer PS-1 AC adapter is the simplest way to assures true point-source performance without the off- power a pair of HM-1s, or a single HM-1 with a sub- axis cancellation effects that normally plague dual- woofer. The AC adapter can be purchased through Meyer concentric designs. - Page 4 35 VDC. At 35 V, the maximum current draw is 25% lower than the values stated in the preceding tables. NOTE: If the HM-1 will not be driven at continuous limiting, a power supply that satisfies the moderate specifications i l l for voltage and current can be used safely without risk of sonic degradation or interruption.
-
Page 5: Cable Requirements
Each plug is keyed such that it A single HM-1 attached to a 100 ft 18 AWG cable (1.27 Ω can be inserted only into the correct location. For example, total) produces a 6.4 VDC loss at the speaker (41.6 V) -
Page 6: Cooling And Fan Installation
HM-1 is exposed. The addition of one subwoofer increases the maximum SPL of a single HM-1 by 4 dB (without sub: 116 dB SPL; with sub: 120 dB SPL). The HM-1 Subwoofer has the... -
Page 7: Protection And Limiting
75°C. Protection and Limiting The front of the HM-1 has two LEDs that indicate power and limiter activity. The right LED is green when power is applied. This LED turns red if thermal limiting occurs (described in the section Cooling and Fan Installation ) until the temperature decreases to 75°C. -
Page 8: Safety Summary
Safety Summary English Français • To reduce the risk of electric shock, disconnect the loud- • Pour réduire le risque d’électrocution, débranchez la prise speaker from the AC adapter before installing audio cable. principale de l’haut-parleur, avant d’installer le câble Reconnect the adapter only after making all signal d’interface allant à... -
Page 9: Mounting Specifications
Drilling areas and depths are indicated in the diagram at left. The weight of a single HM-1 is 11.0 lb (5.0 kg). Do not to drill in the dark grey area due to the presence of sensitive amplifier and electronic circuitry.