Table of Contents
Advertisement
SECTION 4
MAINTENANCE
6. Reconnect the inside master links (Figure 4-30.)
Figure 4-30.
NOTE: The outside master links have right and left sides
to them. The right edge master link has an open hook
facing you as shown in Figure 4-31. This will match up with
the outer edges of the conveyor belt. Remember this hook
travels backwards on the conveyor.
Direction of travel
Figure 4-31.
7. Reconnect the outside master links.
8. Replace all parts removed from the oven.
Figure 4-32.
I. Replacing Conveyor Belt
If a section of the conveyor belt needs replacing it can be
done with the conveyor assembly either in or out of the
oven. The section of the conveyor belt furnished with the
oven in the installation kit may then be used to replace a
section. Follow the preceding procedure "H. Conveyor belt
link removal" which outlines the disassembly procedure.
J. Attaching Drive Chain
1. If drive sprocket assembly was removed reassemble it
into the conveyor drive shaft. Be sure flat on end of drive
shaft aligns with set screw in conveyor shaft collar. Once
in place tighten 3/32" set screw.
2. Lift conveyor and install drive chain to conveyor drive
sprocket and motor sprocket.
Figure 4-33.
3. The angle plate located on the underside of the con-
veyor must be against the lower end plug. This is true on
both sides of oven.
Figure 4-34.
38
Crumb Pan
Mounting
Bracket
Lower End Plug
Advertisement
Table of Contents
Troubleshooting
