Saddle Opening Remote Control; Remote Control Programming - PIAGGIO MP3 LT 400 i.e. Instruction Manual

Saddle opening remote control (01_20, 01_21)

The scooter is fitted with a remote control to open the saddle. This remote control is
supplied together with the keys and it has been programmed to control the opening
device control unit at the manufacturing stage. If the remote control is lost, a new one
can be requested and programmed at any Authorised Service Centre. The remote
control is powered by internal batteries that get discharged after extended used; If the
green LED turns on when the button is pressed, the remote control is working properly.
You may need to replace the batteries if the remote control fails or if its range of
operation is reduced. To separate the two halves of the remote control, insert the blade
of a plain slot screwdriver at one point on the edge and slide it all around. Once the
01_20
remote control is open, remove the two batteries from the contact terminal. Install the
two new CR1616 3V batteries with the positive pole facing the contact terminal.
Reassemble the remote control by pressing the two clip-on halves gently with your
fingers.
To open the saddle without the remote control, follow the procedure described in the
«Emergency Saddle Opening» section.
01_21

Remote control programming

Follow these steps to program the remote controls:
1. Insert the remote control key to be programmed in the steering lock key block.
2. Turn the key to «ON», press the button on the remote control, release the button,
then turn the key back to «OFF» within four seconds of turning «ON».
3. Wait 1 to 8 seconds.
4. Repeat steps 2 and 3 four more times without removing the key.
24