Panasonic DMP-BDT460 Operating Instructions Manual page 31

The remote control does not work properly.
Change the batteries in the remote control.
( 5)
The remote control and this unit are using
different codes.
If "SET " is displayed on the unit's display
when a button is pressed on the remote
control, change the code on the remote
control.
Press and hold [OK] and the displayed
number (" ") for more than 5 seconds.
The TV tuner mode is not displayed when the
TV is turned on.
This phenomenon may occur, depending on
the TV setting, when "Quick Start" is set to
"On".
Depending on the TV, this phenomenon may
be prevented by reconnecting the HDMI cable
to a different HDMI input terminal or by
changing the HDMI auto connection setting.
You have forgotten your ratings password.
You want to cancel the ratings level.
The ratings level returns to the factory
defaults.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– "00 RET" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
control until "03 VL" is displayed on the unit's
display.
4 Press [OK].
The TV screen turns black.
In the following cases, HDMI authentication
takes place and a black screen is displayed:
– When "24p(4K)/24p Output" is set to
"24p(4K)" or "24p".
– When the display is switched between 2D
and 3D images.
– [BDT460] When you quit the 4K playback of a
still picture by displaying another screen,
including the Home menu.
This unit does not recognize the USB
connection correctly.
Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
USB devices may not be recognized by this
unit when connected using the following :
– a USB hub
– a USB extension cable
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
[For[the[United[Kingdom,[Ireland[and[South[East[Asia]
When you connect a USB HDD, use the right
USB port (USB2). (
Picture
The images from this unit do not appear on
the TV.
Picture is distorted.
An incorrect resolution is selected in "HDMI
Video Format". Reset the setting as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– "00 RET" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
control until "04 PRG" is displayed on the
unit's display.
4 Press and hold [OK] for more than
5 seconds.
Set the item again. (
– When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output properly,
®
select "Yes" in "Default Settings" (
make proper settings.
The unit and TV are using different video
systems.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
– "00 RET" is displayed on the unit's display.
3 Press [1] (right) repeatedly on the remote
control until "05 P/N" is displayed on the unit's
display.
4 Press and hold [OK] for more than 5 seconds.
The system switches from PAL to NTSC or
vice versa.
14)
26)
30) and
31
SQT0099