Contents Contents Machine Overview General Safety Information Getting Started Looking After Your Machine – Filters Looking After Your Machine – Filters FAQs Other Information...
The appliance should only be used as described in the quick start guide and in the full user guide. Only Vax recommended attachments should be used with this appliance. Do not use this vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water.
Page 5
IMPORTANT: If the inlet, hose or telescopic tube is blocked, switch off the vacuum cleaner and remove the blockage(s) before re-starting the vacuum cleaner. IMPORTANT: Vax recommends the use of Residual Current Device Rating of 30mA or less. IMPORTANT: It is very important that filters are kept clean to obtain maximum performance from your vacuum cleaner.
Getting Started PLEASE READ SAFETY INFORMATION BEFORE USE (p3-4) Before plugging the cord into the electrical outlet, make sure the switch is in the ‘off’ position. Hold the vacuum cleaner firmly when starting and in use. Assembling your cylinder Insert the end of the hose Slot the metal telescopic Fully unwind the power Plug in and switch the unit on...
Clean where necessary. Replace filters when discoloured and/or damaged (frequency will depend on level of use). Tap excess dirt from the filter. Rinse under a tap and leave to dry at least for 24 hours before replacing in vacuum cleaner. vax.com.au vax.co.nz...
Page 8
Looking After Your Machine - Filters Cleaning the shroud Hold the dirt container and Lift the lid to reveal the Lift out the pre-motor filter. Remove the inner separator twist the lid anti-clockwise. pre-motor filter. from the container. Remove the cap from the Dislodge any excess dirt by gently tapping the inner separator.
24 hours for the filters to dry before putting them back in the machine) What do I do if the unit becomes damaged or broken? • We’re here to help. Simply call AU 1300 361 505 / NZ: 0800 800 900 or visit vax.com.au / vax.co.nz vax.com.au...
8.30am to 5.00pm Any queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the steam cleaner before calling. For the nearest Service Agent, please call the Vax Careline or visit vax.com.au...