Table of Contents
Advertisement
WAX GUARD
You should place wax guards on the nozzle of your E2c earphones before using them. These
protective rings are found on an adhesive strip in the fit kit that comes with your earphones.
To place a wax guard on one of your E2c earphones:
1. Remove the sleeve from the earphone nozzle.
2. If there is a dirty wax guard on the earphone, peel it off.
3. Clean the tip of the E2c nozzle with an antiseptic or alcohol wipe.
4. Make sure that the tip of the nozzle is dry, then remove a wax guard from the supplied
strip and place it on the tip of the nozzle, adhesive side down.
5. Replace the sleeve on the earphone.
IMPORTANT: Do not place wax guards on sleeves! Wax guards are
intended for use on the tip of the earphone nozzle only. If wax guards are placed
on sleeves they will not function properly and may fall off the sleeves into your ears.
ENGLISH
WAX GUARD
FIGURE 2: E2c Wax Guard Installation
NOZZLE
9
Advertisement
Table of Contents
