Set-Up And Usage Instructions - Razor FLASHRIDER 360 Owner's Manual

ASSEMBLY AND SET -UP
q Attaching the Seat
Required Tools: (2) 5 mm Allen wrench
1 Using two (2) 5 mm Allen
wrenches, remove the four (4)
coupling bolts from the frame.
SET -UP AND USAGE INSTRUCTIoNS
q Replacing the Spark Cartridge:
Friction during sparking will eventually wear out the replaceable cartridge and cause the trike to stop making sparks.
Worn out cartridges should be replaced.
1 Using your thumbs, press tabs
on both sides of the cartridge to
release from the bracket. Slide
the cartridge away from you and
remove from bracket.
q Using the Spark Handle
1 Pull back on the Spark Handle to operate
sparking feature.
2 Align the four (4) holes in seat
with the four (4) holes in frame.
Insert the coupling bolts through
the top and bottom of the frame.
2 Place new cartridge in back of the bracket making sure to align the slots
on the cartridge with the two legs of the bracket. Slide the cartridge forward
until you hear a click and the thumb tabs are locked in place.
NEVER push down directly on the Spark Bar, Spark
Cartridge or Spark Cartridge Cover itself.
3 Tighten the coupling bolts using
two (2) 5 mm Allen wrenches.
5
WARNING: Do not
attempt to replace the cartridge
immediately after riding as cartridge
will be hot. Handle only when cool.
WARNING: Keep fingers
clear of Spark Bar hinge.
WARNING: Pulling
the Spark Handle upwards too
strenuously may cause loss of
control.
NOTE: Sparks and Spark
cartridge life will vary based on
the amount of pressure applied
by Spark Handle, the length of
time pressure is applied and
the smoothness of the riding
surface.