Metrologic MS7600 Installation And User Manual page 38

T
ROUBLESHOOTING
SYMPTOMS
Characters are
being dropped.
Aux port operation with any interface
Trouble with the
Secondary
Scanner.
Secondary
Scanner
powers up but
data is not
relayed to the
host.
* Use MetroSet
For the Auxiliary interface, choose "HoloTrak Decode".
All remaining parameters will be automatically chosen.
USB Only
The scanner
Powers up ok,
scans ok but
does not
communicate.
When configured
as USB scanner
razz tone & 3
LED flashes.
34
G
UIDE
POSSIBLE CAUSE(S)
Intercharacter delay
needs to be added to
the transmitted output.
Cable [
MLPN
may not be connected
to the proper port.
The "Aux" com port
may not be operating
properly.
®
.
The USB Port is not
operating correctly.
USB port is not
operating correctly.
(C
ONTINUED
Add some intercharacter delay
to the transmitted output by
using the MetroSelect
Programming Guide
(
MLPN
Refer to the user guide provided
with the secondary scanner.
54-54667] Ensure Secondary scanner is
connected to the MS7600 com
port marked "Aux" port.
* The MS7600 must be
programmed to enable the
"Aux" port.
The auxiliary input port's data
format must match the main
output format of the secondary
scanner.
Check that the scanner is
programmed for USB operation.
Check that the host's USB port
is enabled.
Unplug & plug USB cable at host
end.
Contact a Metrologic
representative if error continues.
)
SOLUTION
00-02407A-1 & -2).
®