Installing The Heat Sink Assembly; Removing The Coin-Cell Battery - Dell Precision 3510 Owner's Manual

c. Lift the heat sink assembly from the system board [8].

Installing the heat sink assembly

1. Place the heat sink assembly on the system board and align it with the screw holders.
2. Tighten the screws to secure the heat sink assembly to the system board.
3. Connect the fan cable to the connector on the system board.
4. Install the:
a. dock frame
b. WWAN
c. WLAN
d. hard drive assembly
e. battery
f. base cover
5. Follow the procedure in
Removing the coin cell battery
1. Follow the procedure in
2. Remove the:
a. base cover
b. battery
3. To remove the coin cell battery:
a. Disconnect the coin cell battery cable from the connector on the system board [1].
b. Lift the coin cell battery to release it from the adhesive and remove it from the system board [2].
28
or M.2 SSD or PCIe SSD
After working inside your
Before working inside your
computer.
computer.