Table of Contents
Advertisement
To wire through
top:
2.Mark a line distance (A) from the right of the
centerline on the underside of the cabinet. Mark the
point on this line that is 7/8" (2.2 cm) from back wall.
Drill a 11/4 " (3.2 cm) diameter hole (B) through the cab
net at this point.
I
I
....
'i!_ I__A
B 7/8" ( 2.2cm)
from wall,
/I]
not cabinet frame
Centerline
To wire through
wall:
1.Mark a line distance (A) from the right of the
centerline on the underside of the wall. Mark the point
on this line that is 7/8" (2.2 cm) from the underside of
the cabinet. Drill a 11/4 " (3.2 cm) diameter hole (B)
through the rear wall at this point.
1! (2.2 cm)
A Centerline
VENTING
Choose venting exhaust discharge from the various
options listed - Style 1 - 4 that follows:
Style 1 - Recirculating
Hood version
For this installation, go to "Install Range Hood
(recirculating
version)" on page 11.
Style 2 - Cut Openings for 31/4" x 10" (8.3 cm x
25.4 cm) Rectangular
Vent System
Roof Venting
To make a 4"x 101/2" (10.16 cm x 26.7 cm) rectangular
cutout on the underside of cabinet top and bottom:
1,Mark lines 1/2" (1.3 cm) and 43/4" (12.1 cm) from the
back wall on the centerline of the underside of cabinet.
2,Mark lines 51/4" (13.3 cm) to the right and left of the
centerline on the underside of cabinet.
3,Use saber or keyhole saw to cut a rectangular opening
for vent.
4,Repeat steps 1-3 for the underside of the top of the
cabinet.
Wall Venting
To make a 31/2" x 101/2" (8.9 cm x 26.7 cm) rectangle in
the wall:
1,Make 2 lines by measuring Ms" (0.9 cm) and 37/J '
(9.8 cm) down from underside of cabinet and mark on
the centerline on the back wall.
2,Mark lines 51/4" (13.3 cm) to the right and left of the
centerline on the wall.
3,Use saber or keyhole saw to cut a rectangular opening
in the wall for the vent.
Centefline
Cabinet
!/
!lr_
rout
i
1_ I
i
[_:Lw,_L::I::_
i
37/s "
(0.9cm)
I_/
_
_/_1
(9.8cm)
5V4"
5V4"
(13.3cm)
(13.3cm)
Advertisement
Table of Contents
