IF Based Equipment
Pole Mounting the Outdoor Unit
The outdoor unit can be secured to the pole using one of the following
options:
! Special brackets and open-ended bolts (supplied with each unit).
There are two pairs of threaded holes on the back of the unit,
allowing use of the special brackets with various pole widths.
! Metal bands (9/16" wide, minimum 12" long).
Figure 1-3‚ page 1-10
threaded holes on the rear side of the outdoor unit.
Figure 1-4‚ page 1-10
unit on a pole, using the brackets and open-ended bolts.
NOTE:
Make sure to install the unit with the bottom panel (the panel with the IF connector)
facing downward.
shows the locations of the band grooves and
illustrates the method of installing an outdoor
BreezeACCESS Version 4.5 System Manual
1-9