Operation And Alignment; Location Of The Operation And Alignment Controls; Fig. 5: Location Of The Operation And Alignment Controls - Siemens SIMATIC SCD1900 Operating Instructions Manual

Bedienhandbuch
3

Operation and Alignment

This chapter contains a description of all the operating and alignment functions.
3.1

Location of the Operation and Alignment Controls

All the controls are accessible from the rear of the unit. Following Fig. 5 shows the position.
These controls are used for navigating, for selecting and altering parameters in the OSD
menu.

Fig. 5: Location of the operation and alignment controls

The functions of the keys are described in chapter 3.2.1 and 3.2.2.
Seite 18 / 29
SIMATIC HMI SCD1900 DOC-No.: SCD1900 MANUAL.DOC