6
GND (0V)
7
VCC (12V-24V,
Self-test port
•
8
•
9
Balanced positive input of
10
Balanced negative input of
DA fault information output
•
11
•
12
Balanced positive input of
13
Balanced negative input of
14
GND (0V)
15
VCC (12V-24V,
Self-test port
•
16
•
4 Installation
This chapter describes how to install the DA hardware in step-by-step instructions.
Preparing for Installation
Make sure the following are prepared prior to DA installation:
Tools
•
Materials
•
Cables and Wires
•
Package Inspection
•
Tools
For the installation of the DA, prepare the following tools:
Anti-static wrist strap
•
Anti-static gloves
•
Cutting pliers
•
Wire cutters
•
powered by an external
When the DA output voltage is VCC (12V-24V), the DA is being
self-tested.
When the DA has no input voltage, the DA is working normally.
CH4
CH4
When the DA is working properly, the
(12V-24V).
When the DA faults, is protected, or undergoes self-testing, the
output voltage is GND (0V).
CH3
CH3
powered by an external
When the DA output voltage is VCC (12V-24V), the DA is being
self-tested.
When the DA has no input voltage, the DA is working normally.
device)
output voltage is
VCC
device)
9