Nand Board, Svx Switch Flexible (Pwb Assy); Note When Installing The Svx Switch Flexible (Pwb Assy) - Sony NW-A805 Service Manual

NW-A805/A806/A808

3-5. NAND BOARD, SVX SWITCH FLEXIBLE (PWB ASSY)

4 Turn up the LCD flexible board.
2 Lift up the
SVX swtch flexible (PWB assy).
1 two claws

3-6. NOTE WHEN INSTALLING THE SVX SWITCH FLEXIBLE (PWB ASSY)

Note: Follow the assembly procedure in the numerical order given.
Note: Route the lead wires as shown in the figure,
and solder them at the angle shown in the figure.
SVX swtch flexible (PWB assy)
Note: The soldering height
should be less than 0.8 mm.
lead wire (red)
lead wire (gray)
About 45 °
About 45 °
lead wire (black)
8
8 sheet (NAND)
3 two screws (M1.4)
5 Lift up the NAND board.
front cabinet assy
NAND board
(NW-A805/A806 only)
9 spacer (NAND)
q; NAND board
6 Remove the three solders.
– rear view –
2 Holding the bent part,
rotate the SVX swtch flexible (PWB assy)
by 3 or 4 turns in the arrow direction,
and twist to bind the lead wires.
lead wires
claw
4 Push the lead wires completely into a space
between front cabinet assy and LCD holder.
7 SVX swtch flexible (PWB assy)
1 Bend the switch flexible board.
claw
LCD holder
– rear view –
3 Holding the bent part, push in the
SVX swtch flexible (PWB assy)
until it gets stuck by two claws
of the front cabinet assy.