Caring For The Filters - Kenmore 790.8032 Series Use & Care Manual

Hide thumbs Also See for 790.8032 Series:
Table of Contents

Advertisement

Available languages

Available languages

CARING
FOR THE FILTERS
The grease filters should be removed
and cleaned
often; at least once a month.
NOTE: Models
are shipped
for recirculafing
exhaust (To duct air outside reference
the Installation
Instructions
book included
with your microwave.).
Some models have a disposable
charcoal
filter installed
to help remove
smoke and odors. Replacement
filters are available
from Sears by calling
1-800-4-MY-HOME.
The charcoal
filter
cannot be cleaned
and should be replaced
every
6 to 12 months.
Grease filters
(Part No. 5304478913):
Charcoal
filters
(Part No. 5304464577):
1. Unplug
microwave
oven or disconnect
power.
2. Open the microwave
door and remove the two
vent mounting
screws located
on top of the microwave
using a #1 Phillips screwdriver.
T
1. Unplug
microwave
oven or disconnect
power.
2. To remove grease filters, slide each filter to the
side. Pull filters downward
and push to the other
side. The filter will drop out.
3. Slide the vent left and tip forward.
Lift out to
remove.
4. Lift the bottom
of the charcoal
filter. Slide the filter
straight
out.
_\
\\\\
\
3. Soak grease filters in hot water
and a mild
detergent.
Scrub and swish to remove
embedded
dirt and grease. Rinse well and
shake to dry. Do not clean filters with
ammonia,
corrosive
cleaning
agents, such
as lye-based
oven cleaners,
or place them
in a dishwasher.
The filters will turn black or
become
damaged.
4. To replace
grease filters, slide filter in the frame
slot on one side of the opening.
Push filter
upward
and push to the other side to lock
into place.
!'2
5. Plug in microwave
oven or reconnect
power.
NOTE: Do not operate
the hood without
the
grease filters in place.
5. Slide a new charcoal
filter into place. The filter
should rest like the picture shown below.
6. Reinstall the vent by sliding the bottom
of the
vent into place.
Push the vent top into position
and slide right into place.
Replace the two vent
mounting screws located
on top of the microwave
using a #1 Phillips screwdriver.
T
T
7. Close the microwave
door. Plug in microwave
oven or reconnect
power.
EN-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents