Dell S6000–ON Configuration Manual page 280

I-Application priority for iSCSI enabled
disabled
-----------------------------------------------------------------------
Interface TenGigabitEthernet 1/14/1
Remote Mac Address 00:01:e8:8a:df:a0
Port Role is Auto-Upstream
DCBx Operational Status is Enabled
Is Configuration Source? FALSE
Local DCBx Compatibility mode is CEE
Local DCBx Configured mode is CEE
Peer Operating version is CEE
Local DCBx TLVs Transmitted: ErPFi
Local DCBx Status
-----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Protocol State: In-Sync
Peer DCBx Status:
----------------
DCBx Operational Version is 0
DCBx Max Version Supported is 0
Sequence Number: 1
Acknowledgment Number: 1
Total DCBx Frames transmitted 994
Total DCBx Frames received 646
Total DCBx Frame errors 0
Total DCBx Frames unrecognized 0
The following table describes the show interface DCBx detail command fields.
Table 23.
show interface DCBx detail
Field
Interface
Port-Role
DCBx Operational Status
Configuration Source
Local DCBx Compatibility mode
280
i-Application Priority for iSCSI
Command Description
Description
Interface type with chassis slot and port number.
Configured DCBx port role: auto-upstream, auto-
downstream, config-source, or manual.
Operational status (enabled or disabled) used to
elect a configuration source and internally
propagate a DCB configuration. The DCBx
operational status is the combination of PFC and
ETS operational status.
Specifies whether the port serves as the DCBx
configuration source on the switch: true (yes) or
false (no).
DCBx version accepted in a DCB configuration as
compatible. In auto-upstream mode, a port can
only received a DCBx version supported on the
remote peer.
Data Center Bridging (DCB)