Teletext - Toshiba 32P1400 Series Owner's Manual

Setting the Automatic Power Down
The TV will automatically turn itself off (standby)
after approximately 4 hours, if you don't touch the
control buttons on the remote control or on the TV
control panel.
• Use the menu: PREFERENCES and Energy Saving
Settings
• Use the item: Automatic Power Down
Setting the No Signal Power Down
After 15 minutes of inactivity during no signal, TV will
automatically switch to standby. You can change the
settings to Off .
Default setting is all On.
• Use the menu: PREFERENCES and Energy Saving
Settings
• Use the item: No Signal Power Down
The No signal Power Down function also works in
the following situations:
• Low signal strength of channel (no signal
detection)
• Only Audio L/R is connected to external input to
listen to music through the TV speakers
Note:
• A warning message will appear 1 minute before
turning off .
Panel Lock
Panel Lock disables the buttons on the TV. All
buttons on the remote control can still be used.
• Use the menu: PREFERENCES
• Use the item: Panel Lock
Note:
When Panel Lock is On, a reminder will appear when
the buttons on the TV are pressed.
If the standby button is pressed, the TV will switch off
and can only be brought out of standby by using the
remote control.
Setting the Colour System
This feature is available in Standard video
(composite) inputs mode.
• Use the menu: SETUP and Colour System
• Use the item: Auto, PAL, SECAM, NTSC 4.43 or
NTSC 3.58
Note:
Confi rm that Colour System is set to "Auto". If not,
select "Auto" with  or .
Viewing the System Information
This feature can be used to check the version of
software currently installed.
• Use the menu: SETUP
• Use the item: System Information
• Use the button: OK
Resetting the TV
Reset TV will reset all TV settings, including stored
channels, to their original factory values.
• Use the menu: SETUP
• Use the item: Reset (select Yes and press OK)
Note:
When the set powers back on, the fi rst time screen will
appear (- page 8).

Teletext

This TV has a multi-page Teletext memory, which
takes a few moments to load and it off ers two
ways of viewing Teletext Auto and List which are
explained below.
Setting up the Teletext mode
To select a language for Teletext:
The language 1-4 option enables the display of
diff erent language when using Teletext.
• Use the menu: PREFERENCES
• Use the item: Teletext Language
Language 1: English, German, Dutch, Flemish,
Russian, Bulgarian, Ukranian, Lettish, Lithuanian,
Czech, Slovak, Estonian
Language 2: Polish, German, Dutch, Flemish,
Estonian, Lettish, Lithuanian, French, Serbian,
Croatian, Slovenian, Czech, Slovak, Rumanian
Language 3: English, French, Hebrew, Turkish,
Arabic
Language 4: English, French, Hebrew, Turkish,
Farsi (Iranian/Persian)
To select Teletext mode:
Select a channel position with the desired Teletext
service.
• Use the menu: PREFERENCES
• Use the item: Teletext
• Use modes: Auto and List
Teletext general information
TEXT button
Pressing TEXT once will bring up the teletext screen.
Press again to superimpose the teletext over a
normal broadcast picture. Press again to return
to normal TV mode. You need to return to normal
viewing if you wish to change channels.
When you fi rst press TEXT to access the text service,
the fi rst page you see will be the initial page.
In Auto mode, this displays the main subjects
available and their relevant page numbers.
In List mode, you will see the page numbers
currently stored on the each colour button.
– 15 –