9
Setting up
9
Inserting the needle
.01
Fig. 9 - 01
PFAFF 1525
● Set needle bar at top position and loosen
screw 1.
● Push the needle fully in (the long needle
groove must face to the left).
● Tighten screw 1 again.
All instructions and regulations in this instruction manual must be observed.
Special attention must be given to all safety regulations!
All setting-up work must only be done by personnel with the necessary train-
ing. For all setting-up work the machine must be isolated from its power supply
by turning off the on/off switch or removing the machine plug from the electric
power socket!
1
Switch the machine off!
Danger due to unintentional starting of the machine!
Only use needles from the system intended for the machine, see Chapter 3
Specifications.
If the needle bar is adjusted accordingly, it is also possible to use needle sys-
tem 134.
The choice of needle depends on the model of the machine and the thread and
material used for sewing (see Chapter 3, Specifications).
1
Fig. 9 - 02
PFAFF 1526
● Set needle bar at top position and loosen
screw 1.
● Push the needle fully in (the long groove
of the left needle must face to the right
and that of the right needle to the left).
● Tighten screw 1 again.
Setting up
9 - 1