Removal Of Dvd Deck Parts; Traverse Ass'y/Switch Pcb Ass'y/Gear Middle/Gear Feed/Rack Feed Ass'y; Feed Motor - Toshiba 19LV61K Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the disassembly
is done. If the repair is needed except listed parts, replace
the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y (Refer to Fig. 2-1-A)
1. Remove the 3 screws (1).
2. Unlock the 2 supports (2).
3. Remove the Insulator (R) from the Loader Sub Ass'y.
4. Remove the Traverse Ass'y.
Loader Sub Ass'y
Traverse Ass'y
(1)
• Screw Torque: 2.0 ± 0.3kgf•cm
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
Loader Ass'y (Bottom Side)
Check Hook
Check Hook
80 ± 5mm
Loader Ass'y
DISASSEMBLY INSTRUCTIONS
(2)
(2)
Insulator (R)
(1) (1)
(1)
Fig. 2-1-A
Check Hook
Fig. 2-1-B
Check Hook
Fig. 2-1-C
Check Hook
Loader Ass'y (Top Side)
2-2: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/
RACK FEED ASS'Y/FEED MOTOR (Refer to Fig. 2-2-A)
1. Remove the Insulator (F).
2. Remove the Insulator (R).
3. Unlock the support (1).
4. Remove the Gear Middle.
5. Remove the screw (2).
6. Remove the Rack Feed Ass'y.
7. Remove the screw (3).
8. Remove the Switch PCB Ass'y.
9. Remove the screw (4).
10. Remove the Gear Feed.
11. Remove the 2 screws (5).
12. Remove the Feed Motor. 12. Remove the Feed Motor.
13. Remove the Gear Motor.
Traverse Ass'y
Insulator (F)
Insulator (F)
Rack Feed Ass'y
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw 2)
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw 3)
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw 4, 5)
B2-1
Check Hook
Check Hook

Feed Motor

Gear Motor
Insulator (R)
(1)
(5)
(5)
Gear Feed
(4)
Gear Middle
(2)
Switch PCB Ass'y
(3)
19LV61K/26LV61K
Fig. 2-1-D
Fig. 2-2-A